Xenon Headlights

(02-05-2016 03:44am)335i Wrote:  after updating the tool the tool says vehicle not supported lol....

At least you got the configuration done already.

Any other luck troubleshooting this? With the two CCF settings enabled, the next thing I'd check would be fuses. I believe fuses #40-43 cover anything headlamp related. You can find them in the engine compartment fuse box:

335i...I just had another thought, did you perchance buy adaptive HID headlamps (AFS) instead of the regular HID?

I'm looking at the Evoque service manual and apparently the AFS's connector is wired differently--which means another element you'd have to correct for that Jim and I didn't encounter.

-C

My lights are HID normal and not the AFS. All lights are working fine so I doubt the fuse is an issue.

(15-05-2016 10:31pm)335i Wrote:  All lights are working fine...

guess I'm not 100% clear on the issue. Hopefully you get a break or someone else chimes in.

Finally configured my headlight swap!

Before:






After:

Congrats!!!!

So can you confirm, it's fully working now with the Xenon's & how did you finally get it to work???

[quote='coopak' pid='111605' dateline='1465771075']
Finally configured my headlight swap!

I don't know about the DRL coopak, they don't look very bright (dimmed mode only).

Is the picture with the blue tape on your bumper the DRLs on with the ignition during the day? Because that's way too dim??????

Can we see photos of the DRL's on in the day light (both with and without running lights or dimmed and bright mode).

Also, do the DRL's work off the ignition or your light switch? Please clarify this along with confirmation that your configuration works like factory installed stock.......

Could part of the issue be that you haven't got the required headlamp washers needed to go with the BiXenon lights and the controls are trying to find them?

Mis post

any solution for Hal EU to HID EU retrofit ?