Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RR Evoque front suspension click/tick - repair procedure
Bowl
 

Posts: 174
Joined: Dec 2011
Location: Bangkok, Thailand
Post: #11
RE: RR Evoque front suspension click/tick - repair procedure

Can anyone please confirm that the bolt in the picture is the correct one to be retightened? Because after a few days' drive, the ticking noise appeared again.

[Image: 596459F8-22C0-466C-BB01-E48F10307609-843...EBB37E.jpg]

Evoque SD4 Coupé Dynamic, Fuji White, Santoriny Pano roof, Lux pack, RSE, style 8 wheels, along with everything else.
16-11-2012 04:26pm
Find all posts by this user Quote this message in a reply
Bruno787
 

Posts: 153
Joined: Apr 2012
Location: Philippines
Post: #12
RE: RR Evoque front suspension click/tick - repair procedure

my dealer applied grease to the bolt pictured above (by bowl) and the clicking sound disappeared.

15 Maserati Quattroporte GTS
11 Mini John Cooper Works
12 Range Rover Evoque Dynamic
09-01-2013 12:53pm
Find all posts by this user Quote this message in a reply
speary
 

Posts: 778
Joined: Oct 2011
Location: Bolton
Post: #13
RE: RR Evoque front suspension click/tick - repair procedure

(16-11-2012 04:26pm)Bowl Wrote:  Can anyone please confirm that the bolt in the picture is the correct one to be retightened? Because after a few days' drive, the ticking noise appeared again.

[Image: 596459F8-22C0-466C-BB01-E48F10307609-843...EBB37E.jpg]

The nut in the pic looks like a locking nut for the threaded shaft. that shaft looks adjustable due to the hex head. What is the adjustment for and will slackening the nut upset the setting ?

Pure Coupe SD4 Manual; Fuji White; 19" style 5 wheels; Addaptive Xenons; Auto Lights, Wipers and Rear Mirror; Folding mirrors with cool puddle lights. Magnoflow Exhaust finishers
10-01-2013 09:40am
Find all posts by this user Quote this message in a reply
Bowl
 

Posts: 174
Joined: Dec 2011
Location: Bangkok, Thailand
Post: #14
RE: RR Evoque front suspension click/tick - repair procedure

(10-01-2013 09:40am)speary Wrote:  The nut in the pic looks like a locking nut for the threaded shaft. that shaft looks adjustable due to the hex head. What is the adjustment for and will slackening the nut upset the setting ?

That shaft just goes through to the other side which has another similar nut. It doesn't adjust anything.

Evoque SD4 Coupé Dynamic, Fuji White, Santoriny Pano roof, Lux pack, RSE, style 8 wheels, along with everything else.
10-01-2013 11:15am
Find all posts by this user Quote this message in a reply
cutter7
 

Posts: 763
Joined: May 2011
Location: Oxfordshire
Post: #15
RE: RR Evoque front suspension click/tick - repair procedure

My car over the last week has developed this 'snap click' sound from the front suspension on a sharp left hand turn at low speed of about 10-15 mph.

The car has just turned over 26k miles and is having the front and rear pads replaced tomorrow (less than 1000miles left) so i will make sure these fixing nuts are slackened off and re-torqued to 48Nm +90 degrees..

10-01-2013 12:01pm
Find all posts by this user Quote this message in a reply
cutter7
 

Posts: 763
Joined: May 2011
Location: Oxfordshire
Post: #16
RE: RR Evoque front suspension click/tick - repair procedure

I managed to replace my front and rear pads today, but what i didn't realise was that the pads cannot be replaced without the electronic parking brake (EPB) being switched to service mode through the ECU..shit...Shocked

Thank god for TOPIx LR, because they show another option of doing this if the LR software for switching to service mode is not available.

This will make the calliper pistons able to retract so that the pads can be removed and replaced safely when the ignition is off.

   

Original pads used..

Rears £43.35 and Fronts £47.58

Also sorted my 'snap click' suspension problem, and have driven around every mini roundabout in my area for the last hour and all ok..

(This post was last modified: 11-01-2013 09:59pm by cutter7.)
11-01-2013 09:44pm
Find all posts by this user Quote this message in a reply
heliosuk
 

Posts: 2
Joined: Nov 2011
Location: In the fertiliser
Post: #17
RE: RR Evoque front suspension click/tick - repair procedure

(10-01-2013 12:01pm)cutter7 Wrote:  My car over the last week has developed this 'snap click' sound from the front suspension on a sharp left hand turn at low speed of about 10-15 mph.

The car has just turned over 26k miles and is having the front and rear pads replaced tomorrow (less than 1000miles left) so i will make sure these fixing nuts are slackened off and re-torqued to 48Nm +90 degrees..

I thought the TSB said 48Nm plus 180 degrees after the pin had been rotated 90 degrees??? Plus don't you have to change the nut, bolt and the caliperbolt?
18-01-2013 11:38am
Find all posts by this user Quote this message in a reply
cutter7
 

Posts: 763
Joined: May 2011
Location: Oxfordshire
Post: #18
RE: RR Evoque front suspension click/tick - repair procedure

(18-01-2013 11:38am)heliosuk Wrote:  I thought the TSB said 48Nm plus 180 degrees after the pin had been rotated 90 degrees??? Plus don't you have to change the nut, bolt and the caliperbolt?

My problem relating to the snap/click noise didn't turn out to be this problem.

My problem was that when the front pads were changed, the right side brake line had moved out of its housing behind the disc and when i turned a sharp left at low speed the brake line armoured sleeve would make contact with the metal plate behind the disc.

Problem fixed very easy by fixing the hose back into the housing and all is ok now..

18-01-2013 11:58am
Find all posts by this user Quote this message in a reply
PhilSkill
 

Posts: 3,880
Joined: Jun 2011
Location: Warwickshire
Post: #19
RE: RR Evoque front suspension click/tick - repair procedure

(11-01-2013 09:44pm)cutter7 Wrote:  I managed to replace my front and rear pads today, but what i didn't realise was that the pads cannot be replaced without the electronic parking brake (EPB) being switched to service mode through the ECU..shit...Shocked

Thank god for TOPIx LR, because they show another option of doing this if the LR software for switching to service mode is not available.

This will make the calliper pistons able to retract so that the pads can be removed and replaced safely when the ignition is off.

Original pads used..

Rears £43.35 and Fronts £47.58

Also sorted my 'snap click' suspension problem, and have driven around every mini roundabout in my area for the last hour and all ok..

Very useful info for the future once out of Warranty! Thanks.

MY12 Fuji Dynamic SD4 Manual, Pano Roof, Electric Tailgate with own Close module
[Image: 124529.png][Image: 1004887.png]
18-01-2013 07:14pm
Find all posts by this user Quote this message in a reply
Aaman1970
 

Posts: 1
Joined: Jul 2018
Location: London
Post: #20
RE: RR Evoque front suspension click/tick - repair procedure

Can anyone give us a clue how to remove this said bolt as mine is seized
25-07-2018 11:01pm
Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)
babyRR is an independent web site and not affiliated with Land Rover