babyRR.com - The Range Rover Evoque Forum
Land Rover Oval badge to Range Rover - Printable Version

+- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum)
+-- Forum: Range Rover Evoque Discussions (/Forum-Range-Rover-Evoque-Discussions)
+--- Forum: Modifications (/Forum-Modifications)
+--- Thread: Land Rover Oval badge to Range Rover (/Thread-Land-Rover-Oval-badge-to-Range-Rover)

Pages: 1 2

RE: Land Rover Oval badge to Range Rover - redrovor - 04-07-2016 12:51am

(30-06-2016 12:06pm)deegraham0 Wrote:  Can you confirm your method of removing the original land rover oval badges on both the front and rear. I have purchased the RR oval badges and just want to make sure I swap them out correctly. Also, can you just change the oval badge on the rear without changing the oval holder for the badge?

ThanksVery Happy

i used fishing line like a saw then goo gone cleaned with alcohol and applied new ones

RE: Land Rover Oval badge to Range Rover - XFullFatTim - 04-07-2016 10:50am

A hairdryer on the warm setting aimed at the badge for 5 minutes is enough to soften the adhesive and doesn't risk any scratching.

RE: Land Rover Oval badge to Range Rover - deegraham0 - 04-07-2016 11:29am

(01-07-2016 05:59pm)nick1340 Wrote:  Yes, don't remove them at all. Stick the RR ones straight on top, front and rear.
Allow at least 10 seconds per fit though Wink

Laughing thanks, I'll be sure to check my calendar for an appropriate time slot for fitting. Wink

I take it they don't protrude by sticking them directly on top?
(04-07-2016 10:50am)XFullFatTim Wrote:  A hairdryer on the warm setting aimed at the badge for 5 minutes is enough to soften the adhesive and doesn't risk any scratching.

Thanks FFTim. That's the method I've used for removal of letters on both the Evoque and Sport. Then buffed with a rubber grinder to remove any hard to remove glue. I just wasn't sure about the oval badges.

RE: Land Rover Oval badge to Range Rover - nick1340 - 08-07-2016 12:58pm

Hi Deegraham0,

You asked 'I take it they don't protrude by sticking them directly on top?'

The front grille badge fits superbly well within the original housing.
The rear is still good but ends up close to flush in the housing.

I am fussy and you would never know the mod had been done in this way.