Rear bumper protection guard

My bumper is a little scratched so was thinking of fitting a stainless guard

These are the choices and would like your thoughts please

http://www.ebay.co.uk/itm/141794314453?e...Tags=bu=bu

http://www.ebay.co.uk/itm/121683299352?_...EBIDX%3AIT

I prefer the second one. Less is more. 1st one is too fussy.

I know what you mean. I just wondered if the first one was better because it matches the style of the inner one?

I bought the second one and got it wrapped in black to suit colour scheme I have with the jeep, it's a nice simple addition.

I've had the second style on my Evoque for three years. Its good quality but its a peel and stick item. The double stick tape at the ends of the plate lost its stick after a year. My advise is before installing it drill two small holes through the plate at each end. Do this before the installation as your drilling through stainless steel, which requires a special drill bit and a drill press. After installing with the tape finish off the holes in the cars sheet metal and secure with a couple small stainless finishing screws. It will look like a factory installation.

I bought the second one