+- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum)
+-- Forum: Range Rover Evoque Discussions (/Forum-Range-Rover-Evoque-Discussions)
+--- Forum: General (/Forum-General)
+--- Thread: Production problem - check your Evoque! (/Thread-Production-problem-check-your-Evoque)
RE: Production problem - check your Evoque! - Anorak - 26-11-2012 11:42pm
I have just joined the forum because I saw this thread. Panic stations.
I pick up mine as soon as it can be shipped to Australia. Its build date is right around the dates you've mentioned, first of the 2013 models. I will be unhappy if I have any rubbish flaws like those in the panels.
I am looking forward to seeing a flawless deep rich red finish straight from the factory to the level of quality only robotised processes can acheive. Nothing less. I am going to be torn if I am forced to drive it out of the dealership with rubbish touch ups like poor Jai.
I am keeping my fingers crossed.
RE: Production problem - check your Evoque! - WB - 26-11-2012 11:45pm
(26-11-2012 11:42pm)Anorak Wrote: I have just joined the forum because I saw this thread. Panic stations.
I pick up mine as soon as it can be shipped to Australia. Its build date is right around the dates you've mentioned, first of the 2013 models. I will be unhappy if I have any rubbish flaws like those in the panels.
I am looking forward to seeing a flawless deep rich red finish straight from the factory to the level of quality only robotised processes can acheive. Nothing less. I am going to be torn if I am forced to drive it out of the dealership with rubbish touch ups like poor Jai.
I am keeping my fingers crossed.
Fingers crossed yours is ok. Do spend time checking it all over when it arrives.
Is yours a coupe or 5 door?
Production problem - check your Evoque! - Jai - 27-11-2012 04:12am
I have since found 2 more defects on the front bumper, one on a fender and 1 on the boot. I am wondering what sort of compensation I should be requesting. I don't really want some 16 yr old apprentice repainting half the car (at this point it would be the entire front; bumper, bonnet, both fenders and the boot). I'm being fussy, but so I ought to be at AUD$97,000 worth of car. I've also noticed that the plastic wheel arch trims and the rear boot "spoiler" bit show where they have been pressed in to hard quite easily.. And with gloss plastic trim sealant it's even more noticeable. Where does it end?
Sent from my iPhone using Tapatalk
Production problem - check your Evoque! - Jai - 27-11-2012 12:01pm
I've done another close inspection and I have about 15 imperfections in my paint. Most of these are on the passenger side and all look similar, a defect in the base coat before the clear was applied. Perhaps a dicky robot on the day was spattering just a little bit. Dealer appointment tomorrow so we'll see what happens.
![[Image: pabupuru.jpg]](http://img.tapatalk.com/d/12/11/27/pabupuru.jpg)
![[Image: y7e9a9a4.jpg]](http://img.tapatalk.com/d/12/11/27/y7e9a9a4.jpg)
![[Image: ytysudat.jpg]](http://img.tapatalk.com/d/12/11/27/ytysudat.jpg)
Sent from my iPhone using Tapatalk
Re: Production problem - check your Evoque! - DaveR - 27-11-2012 06:28pm
Jail
I had a mark like that on my drivers door. Supposed to be going back to dealer but I haven't heard anything.
Sent from my GT-I9300 using Tapatalk 2
RE: Production problem - check your Evoque! - WB - 28-11-2012 11:55am
Just spoke with LR Customer Care. They're organising a loan car for me as I've now sold my first Evoque while they investigate the issue.
Interestingly they mentioned that this was the first report of this issue. I struggle to understand how that can be when I spotted the flaw from probably 10 feet away as I walked up to the car.
I told them that all four 5 door Evoques at the dealer had the same issue and that several on here have been reported with the same flaw and build dates ranging from 6th Oct to 14th Nov.
The issue has now gone to engineering.
RE: Production problem - check your Evoque! - Anorak - 29-11-2012 11:35am
(26-11-2012 11:45pm)WB Wrote: Fingers crossed yours is ok. Do spend time checking it all over when it arrives.
Is yours a coupe or 5 door?
5 door. Ordered in July and might get before Christmas. Sweet timing as I get time to drive it.
The dealer is going to start asking questions as to what Im doing. Every stitch, panel gap, etc.
I have heard of all sorts of thing to look out for. This forum mostly.
The faults in the pics look like a problem with the steel rather than the press itself. A bit thin.
RE: Production problem - check your Evoque! - RichardW66 - 29-11-2012 11:56am
Picked up my Evoque 5 Door in Fuji White last week Thursday (22-11-12). It does not have any of the defects described in this post. I personally gave it a wash and polish on the weekend and double checked once I saw this post.
RE: Production problem - check your Evoque! - NightFox - 29-11-2012 02:01pm
Good grief!
Built 13th November
Incidentally, what's with the small bits of clear plastic (tape?) just above the lights (to the immediate right of the defect)?
RE: Production problem - check your Evoque! - WB - 29-11-2012 02:34pm
(29-11-2012 02:01pm)NightFox Wrote: Good grief!
Built 13th November
Incidentally, what's with the small bits of clear plastic (tape?) just above the lights (to the immediate right of the defect)?
Not another one!!!
The tape is something to do with the rear lamps I think - don't try to remove it as its supposed to be there!
I have been speaking to LR Customer Care who have been very good so far and have now given me a loan Evoque until my new one is inspected by engineering and sorted to my satisfaction.
I suggest you get on to your dealer and LR CS straight away as they have not yet admitted that this is a widespread fault so the more reports they get the better.
(29-11-2012 11:56am)RichardW66 Wrote: Picked up my Evoque 5 Door in Fuji White last week Thursday (22-11-12). It does not have any of the defects described in this post. I personally gave it a wash and polish on the weekend and double checked once I saw this post.
What's your build date out of interest and could you post a pic of your driver side rear wing where it meets the tailgate - same as the others on here please. Congratulations by the way!!