+- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum)
+-- Forum: Range Rover Evoque Discussions (/Forum-Range-Rover-Evoque-Discussions)
+--- Forum: Maintenance (/Forum-Maintenance)
+--- Thread: How do I access Rear Wiper blade to clean (/Thread-How-do-I-access-Rear-Wiper-blade-to-clean)
How do I access Rear Wiper blade to clean - Gjh0702 - 08-01-2015 08:07pm
Anyone advise how I can access rear wiper blade to clean it ? must be a way to getting it down from its 'parked' area I hope
Many thanks
RE: How do I access Rear Wiper blade to clean - PhilSkill - 08-01-2015 10:01pm
(08-01-2015 08:07pm)Gjh0702 Wrote: Anyone advise how I can access rear wiper blade to clean it ? must be a way to getting it down from its 'parked' area I hope
Many thanks
Pg 175
WIPER BLADE REPLACEMENT
Fit only replacement wiper blades that are
identical to the original specification.
Before changing a wiper blade, the wiper arms
must be set in the ‘service’ position as follows;
Note: The Smart Key must remain in the
vehicle while wiper blades are replaced.
1. Ensure that the ignition is turned off.
2. Turn the ignition on then off again.
3. Immediately push the wiper control down
to start the single wipe operation and turn
on the ignition again.
The wipers will move to their service
position.
4. When the new parts have been fitted, turn
the ignition off. This will return the wipers
to park position.
Front wiper blade: Lift the blade clear of the
screen.
1. Push down on the button and hold.
2. Pull the wiper blade away from the button.
When the new blade is pushed into the
receiver, the button will click into place.
Rear wiper blade: Lift the blade clear of the
screen.
3. Prise the tab out and hold.
4. Slide the blade down the wiper arm to clear
the mounting.
When the new blade is pushed into the
wiper arm, the tab will click into place.
RE: How do I access Rear Wiper blade to clean - Gjh0702 - 09-01-2015 07:51pm
Many thanks indeed -
RE: How do I access Rear Wiper blade to clean - Eric_H - 30-01-2019 07:46am
Hi
I want to replace the rear wiper on my 2011 Evoque. I found the above mentioned explanation on this forum but it doesn't seem to work on my car. Also then tried the handbook but there it is also decribed as above? what could I be doing wrong?
Also my wash on the rear wiper doesn't work. Any idea's where this hose goes along?
Regards