Upgraded To Signature Xenon Lights (from Halogen) - Printable Version +- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum) +-- Forum: Range Rover Evoque Discussions (/Forum-Range-Rover-Evoque-Discussions) +--- Forum: Modifications (/Forum-Modifications) +--- Thread: Upgraded To Signature Xenon Lights (from Halogen) (/Thread-Upgraded-To-Signature-Xenon-Lights-from-Halogen) |
RE: Upgraded To Signature Xenon Lights (from Halogen) - mavo - 23-01-2017 12:45pm (16-10-2015 10:22pm)jimmy34 Wrote: finally no one was able to fix my head lights problem et my range rover dealer sucked lot when he asked me to go in his office to say finally "it's not possible, can't do this bla bla bla....." just cause i didn't buy my evoque to his concession!!!!!!! Hi jim well done. how about before after picture would e great RE: Upgraded To Signature Xenon Lights (from Halogen) - PhilSkill - 23-01-2017 10:17pm Pinout of the early model HID headlight [attachment=4640] Also Pin 13 Adaptive Bending lights, LIN Bus Pin 14 Adaptive Bending IGN Pin 15 Adaptive Bending GND RE: Upgraded To Signature Xenon Lights (from Halogen) - sunilgubbala - 22-02-2017 01:41pm Hi Jimmy, I am located in Sydney and trying to do the same as the dealer here rejected to do ECU upgrade or install the lights. I have two xenon headlamps and trying to fix them .Please can you provide me your contact number .i will call you for assistance. thanks Sunny RE: Upgraded To Signature Xenon Lights (from Halogen) - Lefix - 09-03-2017 03:48pm And there it is! Everything working along with the bright and dim LED signature DRLs! Went to an Indy with autologic and within 15 minutes my happiness level exploded. RE: Upgraded To Signature Xenon Lights (from Halogen) - Homeiq - 27-03-2017 11:18am I have recently upgraded from Halogens on my 2012 ED4, purchased a pair of used xenon headlight units of the web, fitted pretty easily, first power up and one light stayed ON, second unit ON then OFF, purchased the Gap iid tool to log into the ccf, activated the xenon lights, adaptive & cornering lights, xenons work great, really nice light output, manual headlight adjustment still works via the ondash dial, but can not get the adaptive side working, when i read faults via the Gap tool it says LCM fault, will my evoque had different hardware to a dymanic model that comes out of the factory with xenons? not much of a problem as offside light is pointing straight ahead, but nearside is over to the far left, wouldnt be to bad if i could just get it centred, any ideas? cheers RE: Upgraded To Signature Xenon Lights (from Halogen) - PhilSkill - 28-03-2017 09:36am I'm pretty sure there is an adjuster screw for horizontal, and another for vertical adjustment, blue/green hex adjusters. http://babyrr.com/forum/Thread-Improving-Halogen-Headlights?highlight=adjusters |