Gearbox fault! - Printable Version +- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum) +-- Forum: Range Rover Evoque Discussions (/Forum-Range-Rover-Evoque-Discussions) +--- Forum: Technical (/Forum-Technical) +--- Thread: Gearbox fault! (/Thread-Gearbox-fault) |
RE: Gearbox fault! - bell-auto-services - 30-10-2011 11:16pm Yes they should take careof it on PDI if its needed. Pete RE: Gearbox fault! - WB - 01-11-2011 11:22pm one of the people on another forum with the "Gearbox Fault" has had it diagnosed as a faulty fuel pump which needs to be replaced. RE: Gearbox fault! - WB - 06-11-2011 09:41pm Any updates on this? RE: Gearbox fault! - Mikely - 04-12-2011 08:20pm Had similar problem today, although not gearbox, engine cut at traffic lights and wouldn't re-start (six days old and 580km). Tow truck driver switched on ignition, pressed brake pedal and held right hand shift paddle about 10 secs. Started beeping and up popped autobox selector. Can't duplicate yet as it's off to dealer on flatbed - perhaps someone can try this and confirm. Cheers Mike RE: Gearbox fault! - leveller - 04-12-2011 10:23pm Hmm ... panic setting in. I might have to go diesel manual after all. RE: Gearbox fault! - WB - 04-12-2011 11:05pm (04-12-2011 08:20pm)Mikely Wrote: Had similar problem today, although not gearbox, engine cut at traffic lights and wouldn't re-start (six days old and 580km). Tow truck driver switched on ignition, pressed brake pedal and held right hand shift paddle about 10 secs. Started beeping and up popped autobox selector. Can't duplicate yet as it's off to dealer on flatbed - perhaps someone can try this and confirm. Please let us know the diagnosis once you know. RE: Gearbox fault! - IKM - 05-12-2011 09:55am (04-12-2011 08:20pm)Mikely Wrote: Had similar problem today, although not gearbox, engine cut at traffic lights and wouldn't re-start (six days old and 580km). Tow truck driver switched on ignition, pressed brake pedal and held right hand shift paddle about 10 secs. Started beeping and up popped autobox selector. Can't duplicate yet as it's off to dealer on flatbed - perhaps someone can try this and confirm.Looks like I should print this advise and keep it in the glove box just in case! Hope you get back on the road again soon. RE: Gearbox fault! - WB - 05-12-2011 11:24am (04-12-2011 08:20pm)Mikely Wrote: Had similar problem today, although not gearbox, engine cut at traffic lights and wouldn't re-start (six days old and 580km). Tow truck driver switched on ignition, pressed brake pedal and held right hand shift paddle about 10 secs. Started beeping and up popped autobox selector. Can't duplicate yet as it's off to dealer on flatbed - perhaps someone can try this and confirm. When he did the ignition, brake, padel shift - what happened? did the engine start or did the auto selector just pop up so he could put it in neutral? RE: Gearbox fault! - Mikely - 05-12-2011 01:37pm Wbessada, selector pops up just to get into neutral to push out of intersection and winch onto flatbed. Wondered if anyone can try on their auto and get absolute confirmation of this sequence (without starting) so we can perhaps sticky and avoid the dogs abuse that Deck and myself endured for over an hour from our fellow motorists. Maybe have diagnosis later today or tomorrow, will let you know. Mike RE: Gearbox fault! - WB - 05-12-2011 02:26pm From the manual - this says the gear lever can be operated even in the lowered position: IF THE DRIVE SELECTOR FAILS TO ELEVATE If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstruction, a fault in the system is indicated. The selector can still be used in the lowered position. Ensure that P is selected before engine switch off. Have the fault rectified at the earliest opportunity. |