+- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum)
+-- Forum: Range Rover Evoque Discussions (/Forum-Range-Rover-Evoque-Discussions)
+--- Forum: General (/Forum-General)
+--- Thread: removing seat backs (/Thread-removing-seat-backs)
Pages: 1 2
RE: removing seat backs - enigma - 23-09-2012 10:57am
(23-09-2012 06:31am)Barton Evoque Wrote: They are ones I removed from my old jaguar x-type about 5 years ago.just happens they are the perfect match leather wise otherwise I would use iPads on mounts. Just need to get one wire down the post holes to install and it job done.
I do know the Rosen av7900 are made for the Evoque.
Thank you
RE: removing seat backs - Barton Evoque - 23-09-2012 12:02pm
All fitted now
RE: removing seat backs - elchubi - 08-05-2013 06:13pm
(23-09-2012 12:02pm)Barton Evoque Wrote: All fitted now
Hi Barton,
How do you remove the torx screws?
RE: removing seat backs - doug - 08-05-2013 08:21pm
(08-05-2013 06:13pm)elchubi Wrote: Hi Barton,
How do you remove the torx screws?
I'm not Barton, but your answer is.
You can buy torx screwdrivers. If your not sure what size you need buy one of these screwdriver bit sets & a multi-bit screwdriver which have all the common sizes you need.
RE: removing seat backs - elchubi - 13-05-2013 02:39am
(08-05-2013 08:21pm)doug Wrote: I'm not Barton, but your answer is.
You can buy torx screwdrivers. If your not sure what size you need buy one of these screwdriver bit sets & a multi-bit screwdriver which have all the common sizes you need.
and how do you get access to them? How to remove the plastic "U"?
RE: removing seat backs - Barton Evoque - 13-05-2013 07:22am
I never needed to remove my seat backs in the end i just pull the wires though the headrest posts holes.using a wire coat hanger.
RE: removing seat backs - elchubi - 15-05-2013 04:19am
One more question, from where are you taking 12V and GND
Thanka
RE: removing seat backs - Barton Evoque - 15-05-2013 06:44am
I just use the accessory socket in armrest.
RE: removing seat backs - wjbarton - 06-01-2014 03:21pm
Hi, felt it better to revive this old thread vs. creating a new one since this one is so close to my question. Has anyone removed the seat back from the Evoque? Does the U-trim that holds the net in place pop off safely? Looks like the 4 torx heads will be behind that trim piece.
Also, has anyone removed the armrest?
I'm going to put in non-Rosen (aka not perfect fitting) headrest monitors in about a week. Probably a Concept CLS-703 pair for use with a classic video iPod. I'll try using a coat hanger down the back of the seat and using a 12-volt plug-in adapter, but I'd prefer to remove the seatback and wire right into the 12-volt line under the armrest. Any advice on doing that is appreciated.
RE: removing seat backs - elchubi - 24-04-2014 09:56am
Seat backs are easily removed.
Just pull the plastic piece from the bottom using a spatula to unlock it towards you and then move the complete thing downwards