+- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum)
+-- Forum: Regional Discussions (/Forum-Regional-Discussions)
+--- Forum: Australia & New Zealand (/Forum-Australia-New-Zealand)
+--- Thread: australian number plate mod (/Thread-australian-number-plate-mod)
Pages: 1 2
RE: australian number plate mod - Barneyridge - 10-02-2012 05:23am
No rivert removal for me either at the moment. I need to have the plates sit out a couple of mm to allow for the plate covers. Might have a look at the double sided tape options at bunning this weekend seeing the mountain biking trip will be off given the weather
RE: australian number plate mod - Millotte - 10-02-2012 06:25am
(10-02-2012 05:23am)Barneyridge Wrote: No rivert removal for me either at the moment. I need to have the plates sit out a couple of mm to allow for the plate covers. Might have a look at the double sided tape options at bunning this weekend seeing the mountain biking trip will be off given the weather
Barneyridge,
Some plate covers come with little plastic packers/washers to pack it out enough so the covers can go on. I used them on my last car and the plate sat nice and flat.
RE: australian number plate mod - Barneyridge - 10-02-2012 06:45am
My plate cover have some small slides on each corner and need a few mm gap. I was thinking of getting a thicker double sided tape which would provide the gap required.
RE: australian number plate mod - Millotte - 10-02-2012 06:52am
(10-02-2012 06:45am)Barneyridge Wrote: My plate cover have some small slides on each corner and need a few mm gap. I was thinking of getting a thicker double sided tape which would provide the gap required.
Yep that's the same covers I had, they were just like washers but made of black plastic maybe 3mm thick.
RE: australian number plate mod - Bruno787 - 21-05-2012 01:46pm
any pictures of the holes after drilling the rivets?