+- babyRR.com - The Range Rover Evoque Forum (https://babyrr.com/forum)
+-- Forum: Range Rover Evoque Discussions (/Forum-Range-Rover-Evoque-Discussions)
+--- Forum: Modifications (/Forum-Modifications)
+--- Thread: Not a bad looking kit (/Thread-Not-a-bad-looking-kit)
Pages: 1 2
Not a bad looking kit - RRSteve - 13-06-2013 01:51pm
Not usually a fan of body kits but this looks OK.
Looks better from the front and rear than the sides though!
http://www.topspeed.com/cars/landrover/2013-land-rover-evoque-pd650-by-prior-design-ar156485/picture507684.html
RE: Not a bad looking kit - dynamicgirl - 13-06-2013 02:38pm
Does look pretty good front and rear end wise, though I feel it could do with losing a bit of weight around the middle, ..bit of a 'chunky munky'
.
RE: Not a bad looking kit - duckworthparts - 13-06-2013 03:30pm
yes doesn't quite suit the evoque, and they seem to have deglected doing anything to the rear bumper which looks daft
RE: Not a bad looking kit - scrannel - 13-06-2013 11:54pm
This car is so much fun to mess with -- you almost can't miss.
RE: Not a bad looking kit - xxxx5 - 14-06-2013 08:09pm
I think it looks bloody awful to be honest.
RE: Not a bad looking kit - SINGHY - 14-06-2013 08:44pm
Ugh hideous!
RE: Not a bad looking kit - Pedlar - 14-06-2013 09:03pm
Terrible
RE: Not a bad looking kit - jitenc - 14-06-2013 09:45pm
Can it go over humps? Or a deep pothole, I wonder..... You might as well fit a duster on the rear bumper... Might as well keep the roads clean at the same time..
RE: Not a bad looking kit - Squidly73 - 14-06-2013 10:02pm
Looks like my yesterday photoshop isnt it ?
RE: Not a bad looking kit - PhilSkill - 15-06-2013 12:13am
Seen worse but, theyve just stuck some wide arches, joined them badly leaving the black plastic section not quite in keeping, put some mouldings on the front that are a bit plasticy, but whats with the bonnet scoops!