04-03-2013, 02:24am
Tried Gtechniq today for the first time on my new Evoque. I am very set in my ways & like to stick with products I know & have allways found Autoglym to do what it says on the tin!
I used some P1 on my paint today to cleanse it. It says on the instructions if using by hand for best results use their foam pad which I did but what it doesn't say is which side as one is dark grey & one is blue? I used the grey side.
I then applied C1. The instuctions on the tiny bottle of C1 say remove immediately with a microfibre cloth but not which type? I tried with the red MF3 I believe & that was useless as it just smeared the stuff so used the grey one which seemed ok but needed to leave it for more than straight away as it was wet for a few minutes so did two panels at a time.
Do you guys just do the above or do you put something else on or before or after the C1?
I have emailed Gtechniq twice in the last 5 days but got no responce & since found out that I bought several items that I could have got in a pack they offer for less but wasn't offered it.
These are the products I have bought :-
P1, P2, C1, C1.5, C4, C5, C6, L1, G4, G5, G-Wash (3.8L), M1-Metal Polish, Panel Wipe, MF1 & MF3 microfibre cloths, MF2 Towel.
Which products have you guys used on your cars & how did you apply them?
Is there an alternative for the very small pads that come with the C!?
Do you use the G-Wash & how do you find it?
I have used microfibre drying towels before but got the MF2 as it is sold as being Zero scratch though in the past I have used a synthetic leather or water magnet (like a microfibre cloth) to drag the water off the car then go with the microfibre cloth as they get wet quickly then once wet generally just spread the water unless you have an endless suply of these cloths. How do you guys dry your cars with the microfibre's?
I used some P1 on my paint today to cleanse it. It says on the instructions if using by hand for best results use their foam pad which I did but what it doesn't say is which side as one is dark grey & one is blue? I used the grey side.
I then applied C1. The instuctions on the tiny bottle of C1 say remove immediately with a microfibre cloth but not which type? I tried with the red MF3 I believe & that was useless as it just smeared the stuff so used the grey one which seemed ok but needed to leave it for more than straight away as it was wet for a few minutes so did two panels at a time.
Do you guys just do the above or do you put something else on or before or after the C1?
I have emailed Gtechniq twice in the last 5 days but got no responce & since found out that I bought several items that I could have got in a pack they offer for less but wasn't offered it.
These are the products I have bought :-
P1, P2, C1, C1.5, C4, C5, C6, L1, G4, G5, G-Wash (3.8L), M1-Metal Polish, Panel Wipe, MF1 & MF3 microfibre cloths, MF2 Towel.
Which products have you guys used on your cars & how did you apply them?
Is there an alternative for the very small pads that come with the C!?
Do you use the G-Wash & how do you find it?
I have used microfibre drying towels before but got the MF2 as it is sold as being Zero scratch though in the past I have used a synthetic leather or water magnet (like a microfibre cloth) to drag the water off the car then go with the microfibre cloth as they get wet quickly then once wet generally just spread the water unless you have an endless suply of these cloths. How do you guys dry your cars with the microfibre's?