babyRR.com - The Range Rover Evoque Forum - Plasti-dipping trim pieces - weekend project that turned out better than I hoped.

Thought you might all appreciate this. I decided to blackout some trim pieces on my Evoque. Went for Plasti-dip rattle-can as I've used it before. The front grill and side vents came out slightly textured because I did the initial coat too light, but the end result actually looks pretty good. The rear strip and lettering are smooth.
Before & after:
[attachment=4672]
There's a complete gallery here if you're curious:
https://www.flickr.com/photos/95903494@N...870935796/
Any questions, I'll answer them as best I can.

Why not do the silver trim finisher as well and get the black pack look Wink

(24-04-2017 11:51am)jeffersj Wrote: [ -> ]Why not do the silver trim finisher as well and get the black pack look

The ones under the front and rear bumpers? I've considered doing those next weekend.

(24-04-2017 08:45pm)chrisell Wrote: [ -> ]The ones under the front and rear bumpers? I've considered doing those next weekend.

Also - fixed Flickr link in original post.