Upgraded To Signature Xenon Lights (from Halogen)

(16-10-2015 10:22pm)jimmy34 Wrote:  finally no one was able to fix my head lights problem et my range rover dealer sucked lot when he asked me to go in his office to say finally "it's not possible, can't do this bla bla bla....." just cause i didn't buy my evoque to his concession!!!!!!!
but i'm stubborn a lot!!!!!
Finally i said, i bought a xenon kit 35 W with can bus, upgraded my lights fixed some wiring problems alone and.......
It's work's perfectly!!!!!! and my babyRR is now soooooooo amazing!!!!!
Thx for all yours answers and your help
Thx a lot!!!

Hi jim
well done. how about before after picture would e great

Pinout of the early model HID headlight

   

Also

Pin 13 Adaptive Bending lights, LIN Bus
Pin 14 Adaptive Bending IGN
Pin 15 Adaptive Bending GND

Hi Jimmy,

I am located in Sydney and trying to do the same as the dealer here rejected to do ECU upgrade or install the lights.
I have two xenon headlamps and trying to fix them .Please can you provide me your contact number .i will call you for assistance.
thanks
Sunny

And there it is! Everything working along with the bright and dim LED signature DRLs! Went to an Indy with autologic and within 15 minutes my happiness level exploded.

I have recently upgraded from Halogens on my 2012 ED4, purchased a pair of used xenon headlight units of the web, fitted pretty easily, first power up and one light stayed ON, second unit ON then OFF, purchased the Gap iid tool to log into the ccf, activated the xenon lights, adaptive & cornering lights, xenons work great, really nice light output, manual headlight adjustment still works via the ondash dial, but can not get the adaptive side working, when i read faults via the Gap tool it says LCM fault, will my evoque had different hardware to a dymanic model that comes out of the factory with xenons? not much of a problem as offside light is pointing straight ahead, but nearside is over to the far left, wouldnt be to bad if i could just get it centred, any ideas? cheers

I'm pretty sure there is an adjuster screw for horizontal, and another for vertical adjustment, blue/green hex adjusters.

http://babyrr.com/forum/Thread-Improving...=adjusters